On Wed, 2014-07-23 at 07:59 +0100, Ian Campbell wrote: > On Tue, 2014-07-22 at 18:01 -0400, Tom Rini wrote: > > On Fri, Jul 18, 2014 at 08:38:41PM +0100, Ian Campbell wrote: > > > > > This enables the necessary clocks, in AHB0 and in PLL6_CFG. This is done > > > for sun7i only since I don't have access to any other sunxi platforms > > > with sata included. > > > > > > The PHY setup is derived from the Alwinner releases and Linux, but is > > > mostly > > > undocumented. > > > > > > The Allwinner AHCI controller also requires some magic (and, again, > > > undocumented) DMA initialisation when starting a port. This is added > > > under a > > > suitable ifdef. > > > > > > This option is enabled for Cubieboard, Cubieboard2 and Cubietruck based on > > > contents of Linux DTS files, including SATA power pin config taken from > > > the > > > DTS. All build tested, but runtime tested on Cubieboard2 and Cubietruck > > > only. > > > > > > Signed-off-by: Ian Campbell <i...@hellion.org.uk> > > > > Note that this may need rebasing as I was just going to grab it as part > > of the rest of the series but it did not apply cleanly. > > Sorry, it applies on top of the outstanding u-boot-arm PR from > http://patchwork.ozlabs.org/patch/371704/. > > Shall we take care of it in another PR from u-boot-sunxi once Albert is > back and caught up?
In the meantime I've merged u-boot#master into what is on u-boot-sunxi#master, applied this patch and pushed the result to u-boot-sunxi#next. Hans, you were looking for a basis for your next round of sunxi board additions -- this is probably what you want. Nothing else which is ready to go touches boards.cfg. Ian. _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot