Am 23.06.2014 17:56, wrote Markus Niebel: > From: Markus Niebel <markus.nie...@tq-group.com> > > This patch adds the changes to boards.cfg and the board directory > under board/tqc. > > TQMa6 is a family of modules based on Freescale i.MX6. It consists of > TQMa6Q (i.MX6 Quad), TQMa6D (i.MX6 Dual) featuring eMMC, and 1 GiB DDR3 > TQMa6S (i.MX6 Solo) featuring eMMC and 512 MiB DDR3 > > The modules need a baseboard. Initially the MBa6x starterkit mainboard is > supported. To easy support for other mainboards the functionality is splitted > in one file for the module (tqma6.c) and one file for the baseboard (tqma6_ > mba6). > > The modules can be boot from eMMC (on USDHC3) and SPI flash. > > The following features are supported: > - MMC: eMMC on module (on USDHC3) and SD-card (on MBa6x mainboard) > - Ethernet: RGMII using micrel KSZ9031 phy on MBa6x mainboard for TQMa6<x> > module. > The phy needs special configurations for the pad skew registers to adjust > for > the signal routing. > Also support for standard ethernet commands and uppdate via tftp. > - SPI: ECSPI1 with bootable serial flash on module and two additional > chip selects on MBa6x > - I2C: This patch adds support for the I2C busses on the TQMa6<x> modules > (I2C3) > and MBa6x baseboards (I2C1). The LM75 temperature sensors on TQMa6<x> and > MBa6x > are also configured. > - USB: high speed host 1 on MBa6x and support for USB storage > - PMIC: support for pfuze 100 on TQMa6<x> > > Signed-off-by: Markus Niebel <markus.nie...@tq-group.com> > ---
Ping ... any comments or shall I rebase after 2014.07 will be released? Kind regards Markus > History: > > - changes for v3: > - squash the patches as suggested by S. Babic > - fix copy and paste error for MBa6x SD-Card slot > - fix WP handling for MBa6x SD-Card slot > - move PMIC init to board_late_init (power_init_board() does not work) > > - changes for v2: > - fix long line warning as suggested by W. Denk > - remove baudrate from CONFIG_EXTRA_ENV_SETTINGS > - remove unused define CONFIG_TQMA6X_BASEBOARD_NAME > - add missing mmcblkdev definition to mmcboot logic in > CONFIG_EXTRA_ENV_SETTINGS > - add missing stuff for tftp and nfs in CONFIG_EXTRA_ENV_SETTINGS > - fix fdt_file in env (was partially fdt) > - add missing int power_init_board(void) to tqma6.c > _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot