Dear Stefan Roese,
In message <200905141555.33901...@denx.de> you wrote:
>
> > > IDE: Bus 0: OK Bus 1: OK
> > > Device 0: Model: HITACHI_DK23FA-20J Firm: 00M7A0A0 Ser#: 42D182
> > > Type: Hard Disk
> > > Capacity: 19077.1 MB = 18.6 GB (39070080 x 512)
> > > Device 1: Model: Firm: Ser#:
> > > Type: # 1F #
> > > Capacity: not available
> > > Device 2: Model: SanDisk SDCFB-128 Firm: vde 1.10 Ser#: gmo5i311404
> > > Type: Removable Hard Disk
> > > Capacity: 122.5 MB = 0.1 GB (250880 x 512)
> > > Device 3: Model: Firm: Ser#:
> > > Type: # 1F #
> > > Capacity: not available
> >
> > If my understanding is correct, then this is a bug on your hardware.
>
> I don't think so.
I do, because what we see on other hardware looks different:
For example:
U-Boot 1.3.2-rc2-g02e4b4e3 (Feb 28 2008 - 16:46:26)
...
IDE: Bus 0: ..OK
Device 0: Model: HITACHI_DK23DA-20 Firm: 00J2A0A1 Ser#: 12Y0MN
Type: Hard Disk
Capacity: 19077.1 MB = 18.6 GB (39070080 x 512)
Device 1: not available
SRAM: 512 kB
...
If your board probes for a non-existing Device 1 and tries to print
Model and Firmware versions, then there must be something wrong...
Best regards,
Wolfgang Denk
--
DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: w...@denx.de
Many aligators will be slain, but the swamp will remain.
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
