I am trying to run FALCON MODE on zynq-microzed board. I am following
README-falcon.But when i run `nand read 82000000 kernel` command, i get
this error..
****no devices available****
And when i run u-boot it shows..
**
> NAND: zynq_nand_init: Unable detect NAND based on MIO settings ZYNQ
> NAND init failed
**
**Here are messages from my u-boot.**
U-Boot 2014.01 (May 26 2014 - 11:19:45)
I2C: ready
Memory: ECC disabled
DRAM: 1 GiB
**NAND: zynq_nand_init: Unable detect NAND based on MIO settings
ZYNQ NAND init failed**
0 MiB
MMC: zynq_sdhci: 0
SF: Detected S25FL128S_64K with page size 256 Bytes, erase size 64 KiB,
total 16 MiB
*** Warning - bad CRC, using default environment
In: serial
Out: serial
Err: serial
Net: Gem.e000b000
Hit any key to stop autoboot: 0
zynq-uboot> nand read 82000000 kernel
**no devices available**
zynq-uboot>
I have to use nand command, so please tell me how can i resolve this
problem.
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
