Hi Josh,

On 05/19/2014 07:51 PM, Josh Wu wrote:
Add to code to flush the dcache after we writing in DMA buffer.
Also we need invalidate the dcache before we check the status in the
DMA buffer.

Tested in SAMA5D3x-EK with gmac0. Tftp download speed shows in below:
        Disable DCache: 1.1 MiB/s
        Enable DCache: 1.6 MiB/s
Increase speed with about 40%.

The code should have no impact with the boards which are not
enable_dcache().
Tested in AT91SAM9M10G45EK.

Signed-off-by: Josh Wu <josh...@atmel.com>

For this patch set, tested ok on sama5d3xek board.

Tested-by: Bo Shen <voice.s...@atmel.com>
Acked-by: Bo Shen <voice.s...@atmel.com>

Best Regards,
Bo Shen

---
v1 -> v2:
   no change.

  drivers/net/macb.c |   51 +++++++++++++++++++++++++++++++++++++++++++++++++++
  1 file changed, 51 insertions(+)

diff --git a/drivers/net/macb.c b/drivers/net/macb.c
index 781a272..b18f07b 100644
--- a/drivers/net/macb.c
+++ b/drivers/net/macb.c
@@ -194,6 +194,39 @@ int macb_miiphy_write(const char *devname, u8 phy_adr, u8 
reg, u16 value)
  }
  #endif

+#define        IS_RX   1
+#define        IS_TX   0
+static inline void macb_invalidate_ring_desc(struct macb_device *macb, bool 
is_rx)
+{
+       if (is_rx)
+               invalidate_dcache_range(macb->rx_ring_dma, macb->rx_ring_dma +
+                       CONFIG_SYS_MACB_RX_RING_SIZE * sizeof(struct 
macb_dma_desc));
+       else
+               invalidate_dcache_range(macb->tx_ring_dma, macb->tx_ring_dma +
+                       CONFIG_SYS_MACB_TX_RING_SIZE * sizeof(struct 
macb_dma_desc));
+}
+
+static inline void macb_flush_ring_desc(struct macb_device *macb, bool is_rx)
+{
+       if (is_rx)
+               flush_dcache_range(macb->rx_ring_dma, macb->rx_ring_dma +
+                       CONFIG_SYS_MACB_RX_RING_SIZE * sizeof(struct 
macb_dma_desc));
+       else
+               flush_dcache_range(macb->tx_ring_dma, macb->tx_ring_dma +
+                       CONFIG_SYS_MACB_TX_RING_SIZE * sizeof(struct 
macb_dma_desc));
+}
+
+static inline void macb_flush_rx_buffer(struct macb_device *macb)
+{
+       flush_dcache_range(macb->rx_buffer_dma,
+               macb->rx_buffer_dma + CONFIG_SYS_MACB_RX_BUFFER_SIZE);
+}
+
+static inline void macb_invalidate_rx_buffer(struct macb_device *macb)
+{
+       invalidate_dcache_range(macb->rx_buffer_dma,
+               macb->rx_buffer_dma + CONFIG_SYS_MACB_RX_BUFFER_SIZE);
+}

  #if defined(CONFIG_CMD_NET)

@@ -217,6 +250,9 @@ static int macb_send(struct eth_device *netdev, void 
*packet, int length)
        macb->tx_ring[tx_head].ctrl = ctrl;
        macb->tx_ring[tx_head].addr = paddr;
        barrier();
+       macb_flush_ring_desc(macb, IS_TX);
+       /* Do we need check paddr and length is dcache line aligned? */
+       flush_dcache_range(paddr, paddr + length);
        macb_writel(macb, NCR, MACB_BIT(TE) | MACB_BIT(RE) | MACB_BIT(TSTART));

        /*
@@ -225,6 +261,7 @@ static int macb_send(struct eth_device *netdev, void 
*packet, int length)
         */
        for (i = 0; i <= CONFIG_SYS_MACB_TX_TIMEOUT; i++) {
                barrier();
+               macb_invalidate_ring_desc(macb, IS_TX);
                ctrl = macb->tx_ring[tx_head].ctrl;
                if (ctrl & TXBUF_USED)
                        break;
@@ -253,6 +290,8 @@ static void reclaim_rx_buffers(struct macb_device *macb,
        unsigned int i;

        i = macb->rx_tail;
+
+       macb_invalidate_ring_desc(macb, IS_RX);
        while (i > new_tail) {
                macb->rx_ring[i].addr &= ~RXADDR_USED;
                i++;
@@ -266,6 +305,7 @@ static void reclaim_rx_buffers(struct macb_device *macb,
        }

        barrier();
+       macb_flush_ring_desc(macb, IS_RX);
        macb->rx_tail = new_tail;
  }

@@ -279,6 +319,8 @@ static int macb_recv(struct eth_device *netdev)
        u32 status;

        for (;;) {
+               macb_invalidate_ring_desc(macb, IS_RX);
+
                if (!(macb->rx_ring[rx_tail].addr & RXADDR_USED))
                        return -1;

@@ -292,6 +334,8 @@ static int macb_recv(struct eth_device *netdev)
                if (status & RXBUF_FRAME_END) {
                        buffer = macb->rx_buffer + 128 * macb->rx_tail;
                        length = status & RXBUF_FRMLEN_MASK;
+
+                       macb_invalidate_rx_buffer(macb);
                        if (wrapped) {
                                unsigned int headlen, taillen;

@@ -506,6 +550,9 @@ static int macb_init(struct eth_device *netdev, bd_t *bd)
                macb->rx_ring[i].ctrl = 0;
                paddr += 128;
        }
+       macb_flush_ring_desc(macb, IS_RX);
+       macb_flush_rx_buffer(macb);
+
        for (i = 0; i < CONFIG_SYS_MACB_TX_RING_SIZE; i++) {
                macb->tx_ring[i].addr = 0;
                if (i == (CONFIG_SYS_MACB_TX_RING_SIZE - 1))
@@ -513,6 +560,8 @@ static int macb_init(struct eth_device *netdev, bd_t *bd)
                else
                        macb->tx_ring[i].ctrl = TXBUF_USED;
        }
+       macb_flush_ring_desc(macb, IS_TX);
+
        macb->rx_tail = macb->tx_head = macb->tx_tail = 0;

        macb_writel(macb, RBQP, macb->rx_ring_dma);
@@ -663,6 +712,8 @@ int macb_eth_initialize(int id, void *regs, unsigned int 
phy_addr)
                                           * sizeof(struct macb_dma_desc),
                                           &macb->tx_ring_dma);

+       /* TODO: we need check the rx/tx_ring_dma is dcache line aligned */
+
        macb->regs = regs;
        macb->phy_addr = phy_addr;



_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot

Reply via email to