From: "Poddar, Sourav" <sourav.pod...@ti.com>
Bulk erase is not happening properly on dra7 due to erase timing constraints,
add a delay so that erase timing constraints are properly met.
Signed-off-by: Sourav Poddar <sourav.pod...@ti.com>
Tested-by: Yebio Mesfin <ymes...@ti.com>
---
drivers/spi/ti_qspi.c | 3 +++
1 file changed, 3 insertions(+)
diff --git a/drivers/spi/ti_qspi.c b/drivers/spi/ti_qspi.c
index dfa5d0c..c5d2245 100644
--- a/drivers/spi/ti_qspi.c
+++ b/drivers/spi/ti_qspi.c
@@ -314,6 +314,9 @@ int spi_xfer(struct spi_slave *slave, unsigned int bitlen,
const void *dout,
qslave->cmd |= QSPI_RD_SNGL;
debug("rx cmd %08x dc %08x\n",
qslave->cmd, qslave->dc);
+ #ifdef CONFIG_DRA7XX
+ udelay(500);
+ #endif
writel(qslave->cmd, &qslave->base->cmd);
status = readl(&qslave->base->status);
timeout = QSPI_TIMEOUT;
--
1.7.9.5
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
