Hi > > On 03/27/2014 05:32 PM, Tim Sander wrote: > > > Hi Michal > > > > > > Am Donnerstag, 27. März 2014, 14:17:41 schrieb Michal Simek: > > >>>>>> Please check and may be you can try u-boot-dtb.elf. > > >>>>> > > >>>>> Mh, don't know how to create this kind of file? > > >>>> > > >>>> Jagan maybe knows more but I don't think u-boot-dtb.elf is generated. > > >>>> Just u-boot-dtb.bin is generated which should be copied as data file > > >>>> in xmd and not sure if binary file can be directly used for bootgen. > > > > > > If adding the dtb file in the boot.bif file is not the right way and no > > > elf file with dtb is generated: What is the right way to generate an > > > image for use with the SD-Card? > > > > you can just use static u-boot configuration. > > I assume you mean static configuration a config with OF_CONTROL disabled. > Ok, i have tried to boot that with bootgen. That does not work. > Loading that into memory and booting it from within the debugger works > though. In both cases with or without OF_CONTROL enabled. > > > I have never tried to add dtb as partition to boot.bin. > > If you want to use this dtb driver u-boot I would suggest you > > to look at u-boot SPL which should be able to handle binary formats > > with dtbs. > > So my main focus is to test CONFIG_ARMV7_NONSEC to boot linux in > normal mode. I wanted to test recent mainline with that. So focusing on > u-boot SPL is to far off my targets. So i am happy with hardware debugger > loadeing for the time beeing. > > Getting back to CONFIG_ARMV7_NONSEC. This is unfortunatly not working with > the Zynq. Currently the board switches to monitor mode but when the u-boot > switches to normal mode it jumps to PC:0xc (LR:0x10) which seems like a > data abort exeption or some other secure mode violation exception? > Is there a good way to find out what happened? I am currently stuck with > this and my local FAE has also no idea. Attached is a patch which at least > works until the return from the monitor mode. Just a small information: I can boot a OF_CONTROL on a RevC Zynq Board but not Rev. D. So i can at least confirm that a board with RevC boots a mainline u-boot with OF_CONTROL disabled. I have no idea why the bootgen for the Rev. D board fails even if i have replaced the bitstream for the non eng. sample FPGA. But at least that also works when loaded with an HW-Debugger.
Best regards Tim _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
