Add #ifdef CONFIG_SUN?I were appropriate to make adding sun4i / sun5i support
later easier.
Signed-off-by: Hans de Goede <hdego...@redhat.com>
---
arch/arm/cpu/armv7/sunxi/dram.c | 25 ++++++++++++++++++++++++-
1 file changed, 24 insertions(+), 1 deletion(-)
diff --git a/arch/arm/cpu/armv7/sunxi/dram.c b/arch/arm/cpu/armv7/sunxi/dram.c
index fd3f488..555b75d 100644
--- a/arch/arm/cpu/armv7/sunxi/dram.c
+++ b/arch/arm/cpu/armv7/sunxi/dram.c
@@ -116,6 +116,7 @@ static void mctl_enable_dllx(u32 phase)
}
static u32 hpcr_value[32] = {
+#ifdef CONFIG_SUN7I
0x0301, 0x0301, 0x0301, 0x0301,
0x0301, 0x0301, 0x0301, 0x0301,
0, 0, 0, 0,
@@ -129,6 +130,7 @@ static u32 hpcr_value[32] = {
* but boot0 code skips #28 and #30, and sets #29 and #31 to the
* value from #28 entry (0x1031)
*/
+#endif
};
static void mctl_configure_hostport(void)
@@ -162,11 +164,13 @@ static void mctl_setup_dram_clock(u32 clk)
setbits_le32(&ccm->pll5_cfg, CCM_PLL5_CTRL_DDR_CLK);
+#if defined(CONFIG_SUN4I) || defined(CONFIG_SUN7I)
/* reset GPS */
clrbits_le32(&ccm->gps_clk_cfg, CCM_GPS_CTRL_RESET | CCM_GPS_CTRL_GATE);
setbits_le32(&ccm->ahb_gate0, CCM_AHB_GATE_GPS);
udelay(1);
clrbits_le32(&ccm->ahb_gate0, CCM_AHB_GATE_GPS);
+#endif
/* setup MBUS clock */
reg_val = CCM_MBUS_CTRL_GATE |
@@ -193,7 +197,9 @@ static int dramc_scan_readpipe(void)
u32 reg_val;
/* data training trigger */
+#ifdef CONFIG_SUN7I
clrbits_le32(&dram->csr, DRAM_CSR_FAILED);
+#endif
setbits_le32(&dram->ccr, DRAM_CCR_DATA_TRAINING);
/* check whether data training process has completed */
@@ -320,15 +326,17 @@ fail:
static void dramc_clock_output_en(u32 on)
{
+#if defined(CONFIG_SUN5I) || defined(CONFIG_SUN7I)
struct sunxi_dram_reg *dram = (struct sunxi_dram_reg *)SUNXI_DRAMC_BASE;
if (on)
setbits_le32(&dram->mcr, DRAM_MCR_DCLK_OUT);
else
clrbits_le32(&dram->mcr, DRAM_MCR_DCLK_OUT);
+#endif
}
-
+#if defined(CONFIG_SUN5I) || defined(CONFIG_SUN7I)
static void dramc_set_autorefresh_cycle(u32 clk)
{
struct sunxi_dram_reg *dram = (struct sunxi_dram_reg *)SUNXI_DRAMC_BASE;
@@ -342,6 +350,7 @@ static void dramc_set_autorefresh_cycle(u32 clk)
reg_val |= 0x8 << 24;
writel(reg_val, &dram->drr);
}
+#endif /* SUN5I */
unsigned long dramc_init(struct dram_para *para)
{
@@ -392,24 +401,32 @@ unsigned long dramc_init(struct dram_para *para)
reg_val |= DRAM_DCR_MODE(DRAM_DCR_MODE_INTERLEAVE);
writel(reg_val, &dram->dcr);
+#ifdef CONFIG_SUN7I
setbits_le32(&dram->zqcr1, (0x1 << 24) | (0x1 << 1));
if (para->tpr4 & 0x2)
clrsetbits_le32(&dram->zqcr1, (0x1 << 24), (0x1 << 1));
dramc_clock_output_en(1);
+#endif
+#if (defined(CONFIG_SUN5I) || defined(CONFIG_SUN7I))
/* set odt impendance divide ratio */
reg_val = ((para->zq) >> 8) & 0xfffff;
reg_val |= ((para->zq) & 0xff) << 20;
reg_val |= (para->zq) & 0xf0000000;
writel(reg_val, &dram->zqcr0);
+#endif
+#ifdef CONFIG_SUN7I
/* Set CKE Delay to about 1ms */
setbits_le32(&dram->idcr, 0x1ffff);
+#endif
+#ifdef CONFIG_SUN7I
if ((readl(&dram->ppwrsctl) & 0x1) != 0x1)
mctl_ddr3_reset();
else
setbits_le32(&dram->mcr, DRAM_MCR_RESET);
+#endif
udelay(1);
@@ -427,7 +444,9 @@ unsigned long dramc_init(struct dram_para *para)
if (para->type == DRAM_MEMORY_TYPE_DDR3) {
reg_val = DRAM_MR_BURST_LENGTH(0x0);
+#if (defined(CONFIG_SUN5I) || defined(CONFIG_SUN7I))
reg_val |= DRAM_MR_POWER_DOWN;
+#endif
reg_val |= DRAM_MR_CAS_LAT(para->cas - 4);
reg_val |= DRAM_MR_WRITE_RECOVERY(0x5);
} else if (para->type == DRAM_MEMORY_TYPE_DDR2) {
@@ -444,13 +463,16 @@ unsigned long dramc_init(struct dram_para *para)
/* set DQS window mode */
clrsetbits_le32(&dram->ccr, DRAM_CCR_DQS_DRIFT_COMP, DRAM_CCR_DQS_GATE);
+#ifdef CONFIG_SUN7I
/* Command rate timing mode 2T & 1T */
if (para->tpr4 & 0x1)
setbits_le32(&dram->ccr, DRAM_CCR_COMMAND_RATE_1T);
+#endif
/* reset external DRAM */
setbits_le32(&dram->ccr, DRAM_CCR_INIT);
while (readl(&dram->ccr) & DRAM_CCR_INIT);
+#ifdef CONFIG_SUN7I
/* setup zq calibration manual */
reg_val = readl(&dram->ppwrsctl);
if ((reg_val & 0x1) == 1) {
@@ -486,6 +508,7 @@ unsigned long dramc_init(struct dram_para *para)
udelay(2);
}
+#endif
/* scan read pipe value */
mctl_itm_enable();
--
1.9.0
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
