For low freq boot mode(ARM boot up with 396MHz), ROM
will not set AHB clock to 132MHz, and the reset value of
AHB divider is incorrect which will lead to wrong AHB
rate, need to correct it. To enable low freq boot mode,
need to set BOOT_CFG2[2] to high, tested on i.MX6Q/DL
SabreSD board and i.MX6SL EVK board.
Signed-off-by: Anson Huang <b20...@freescale.com>
---
arch/arm/cpu/armv7/mx6/soc.c | 20 ++++++++++++++++++++
1 file changed, 20 insertions(+)
diff --git a/arch/arm/cpu/armv7/mx6/soc.c b/arch/arm/cpu/armv7/mx6/soc.c
index a390296..edf3139 100644
--- a/arch/arm/cpu/armv7/mx6/soc.c
+++ b/arch/arm/cpu/armv7/mx6/soc.c
@@ -131,10 +131,30 @@ static void imx_set_wdog_powerdown(bool enable)
writew(enable, &wdog2->wmcr);
}
+static void set_ahb_rate(u32 val)
+{
+ struct mxc_ccm_reg *mxc_ccm = (struct mxc_ccm_reg *)CCM_BASE_ADDR;
+ u32 reg, div;
+
+ div = get_periph_clk() / val - 1;
+ reg = readl(&mxc_ccm->cbcdr);
+
+ writel((reg & (~MXC_CCM_CBCDR_AHB_PODF_MASK)) |
+ (div << MXC_CCM_CBCDR_AHB_PODF_OFFSET), &mxc_ccm->cbcdr);
+}
+
int arch_cpu_init(void)
{
init_aips();
+ /*
+ * When low freq boot is enabled, ROM will not set AHB
+ * freq, so we need to ensure AHB freq is 132MHz in such
+ * scenario.
+ */
+ if (mxc_get_clock(MXC_ARM_CLK) == 396000000)
+ set_ahb_rate(132000000);
+
set_vddsoc(1200); /* Set VDDSOC to 1.2V */
imx_set_wdog_powerdown(false); /* Disable PDE bit of WMCR register */
--
1.7.9.5
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
