Hello!

I would like to flash the environment variable values to my board, rather than setting them at the prompt. I've founa a tool mkenvimage is made specially for that. I used it to create a binary image of the U-Boot environment. However, when I flash it to my board, I get the message
*** Warning - bad CRC, using default environment

I thought it is due to that redundant memory wasn't written aswell, so I commented out #define CONFIG_ENV_REDUND_OFFSET in the include/configs/at91sam9g20ek.h, and tried once again, but I'm still getting this error.

What should I do to flash environment values directly to the board's NAND?

Best regards,
Alexey Smishlayev
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot

Reply via email to