This patch allows exiting from UMS mode to u-boot prompt
by detaching usb cable or by pressing ctrl+c.
Add new config: CONFIG_USB_CABLE_CHECK. If defined then board
file should provide function: usb_cable_connected() (include/usb.h)
that return 1 if cable is connected and 0 otherwise.
Changes v2:
- add a note to the README
Signed-off-by: Przemyslaw Marczak <p.marc...@samsung.com>
Cc: Marek Vasut <ma...@denx.de>
---
README | 7 +++++++
common/cmd_usb_mass_storage.c | 21 +++++++++++++--------
drivers/usb/gadget/f_mass_storage.c | 24 +++++++++++++++++++++---
include/usb.h | 10 ++++++++++
4 files changed, 51 insertions(+), 11 deletions(-)
diff --git a/README b/README
index cee8e2f..75329b1 100644
--- a/README
+++ b/README
@@ -1362,6 +1362,13 @@ The following options need to be configured:
for your device
- CONFIG_USBD_PRODUCTID 0xFFFF
+ Some USB device drivers may need to check USB cable attachment.
+ In this case you can enable following config in BoardName.h:
+ CONFIG_USB_CABLE_CHECK
+ This enables function definition:
+ - usb_cable_connected() in include/usb.h
+ Implementation of this function is board-specific.
+
- ULPI Layer Support:
The ULPI (UTMI Low Pin (count) Interface) PHYs are supported via
the generic ULPI layer. The generic layer accesses the ULPI PHY
diff --git a/common/cmd_usb_mass_storage.c b/common/cmd_usb_mass_storage.c
index 4d3bbd8..99487f4 100644
--- a/common/cmd_usb_mass_storage.c
+++ b/common/cmd_usb_mass_storage.c
@@ -5,6 +5,7 @@
* SPDX-License-Identifier: GPL-2.0+
*/
+#include <errno.h>
#include <common.h>
#include <command.h>
#include <g_dnl.h>
@@ -42,16 +43,20 @@ int do_usb_mass_storage(cmd_tbl_t *cmdtp, int flag,
g_dnl_register("ums");
while (1) {
- /* Handle control-c and timeouts */
- if (ctrlc()) {
- error("The remote end did not respond in time.");
- goto exit;
- }
-
usb_gadget_handle_interrupts();
- /* Check if USB cable has been detached */
- if (fsg_main_thread(NULL) == EIO)
+
+ rc = fsg_main_thread(NULL);
+ if (rc) {
+ /* Check I/O error */
+ if (rc == -EIO)
+ printf("\rCheck USB cable connection\n");
+
+ /* Check CTRL+C */
+ if (rc == -EPIPE)
+ printf("\rCTRL+C - Operation aborted\n");
+
goto exit;
+ }
}
exit:
g_dnl_unregister();
diff --git a/drivers/usb/gadget/f_mass_storage.c
b/drivers/usb/gadget/f_mass_storage.c
index 3b77047..d290a56 100644
--- a/drivers/usb/gadget/f_mass_storage.c
+++ b/drivers/usb/gadget/f_mass_storage.c
@@ -245,6 +245,7 @@
#include <config.h>
#include <malloc.h>
#include <common.h>
+#include <usb.h>
#include <linux/err.h>
#include <linux/usb/ch9.h>
@@ -678,6 +679,18 @@ static int sleep_thread(struct fsg_common *common)
k++;
}
+ if (k == 10) {
+ /* Handle CTRL+C */
+ if (ctrlc())
+ return -EPIPE;
+#ifdef CONFIG_USB_CABLE_CHECK
+ /* Check cable connection */
+ if (!usb_cable_connected())
+ return -EIO;
+#endif
+ k = 0;
+ }
+
usb_gadget_handle_interrupts();
}
common->thread_wakeup_needed = 0;
@@ -2390,6 +2403,7 @@ static void handle_exception(struct fsg_common *common)
int fsg_main_thread(void *common_)
{
+ int ret;
struct fsg_common *common = the_fsg_common;
/* The main loop */
do {
@@ -2399,12 +2413,16 @@ int fsg_main_thread(void *common_)
}
if (!common->running) {
- sleep_thread(common);
+ ret = sleep_thread(common);
+ if (ret)
+ return ret;
+
continue;
}
- if (get_next_command(common))
- continue;
+ ret = get_next_command(common);
+ if (ret)
+ return ret;
if (!exception_in_progress(common))
common->state = FSG_STATE_DATA_PHASE;
diff --git a/include/usb.h b/include/usb.h
index 17fb68c..8c1789f 100644
--- a/include/usb.h
+++ b/include/usb.h
@@ -197,6 +197,16 @@ int board_usb_init(int index, enum board_usb_init_type
init);
*/
int board_usb_cleanup(int index, enum board_usb_init_type init);
+/*
+ * If CONFIG_USB_CABLE_CHECK is set then this function
+ * should be defined in board file.
+ *
+ * @return 1 if cable is connected and 0 otherwise.
+ */
+#ifdef CONFIG_USB_CABLE_CHECK
+int usb_cable_connected(void);
+#endif
+
#ifdef CONFIG_USB_STORAGE
#define USB_MAX_STOR_DEV 5
--
1.7.9.5
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
