On Friday 17 April 2009, Richard Retanubun wrote:
> I've tried extracting the information at board_early_init_r (because I need
> to initialize MAC address later using this information also) and store the
> information using setenv("partnum" "extracted_board_id");
>
> However, the resulting printenv after boot only contains "pa" with no data,
> so obviously I am doing something wrong (calling setenv too early?)
>
> Is there a recommended way/examples of doing this?
>
> I've thought about using the global data, but don't know if there is a
> struct member that is arch-independent. Thanks for everyone's time.I suggest you take a look at "gd->board_type" (enabled via CONFIG_BOARD_TYPES). This could be what you are looking for. Best regards, Stefan ===================================================================== DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-0 Fax: +49-8142-66989-80 Email: off...@denx.de ===================================================================== _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
