enable the RBL/UBL ECC layout through CONFIG_NAND_6BYTES_OOB_FREE_10BYTES_ECC define
see for more info: http://processors.wiki.ti.com/index.php/DM365_Nand_ECC_layout and use this on the ipam390 board. Also do some minor changes for this board: - update default environment - change A2CR to correct value for UART boot mode - adapt cs3cfg timings for nand - change LED bootmode signalization Heiko Schocher (2): nand, davinci: add special UBL ecc position arm, da85x: update for the ipam390 board board/Barix/ipam390/ipam390-ais-uart.cfg | 2 +- board/Barix/ipam390/ipam390.c | 29 ++++++++------------------ drivers/mtd/nand/davinci_nand.c | 10 +++++++++ include/configs/ipam390.h | 35 ++++++++++++++++++++------------ 4 Dateien geändert, 42 Zeilen hinzugefügt(+), 34 Zeilen entfernt(-) Signed-off-by: Heiko Schocher <h...@denx.de> Cc: Tom Rini <tr...@ti.com> Cc: Scott Wood <scottw...@freescale.com> -- 1.7.11.7 _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
