As seen on GCC 4.6 Linaro compiler, control_req buffer is not aligned on 4 byte boundaray causing data aborts in eth_setup -> conf_buf during dhcp boot over usb_ether. Fix the issue my aligning control_req buffer to 4-byte boundary.
Tested on am335x_evm platform (beaglebone). Applies on 2013.10-rc1 branch. Cc: Tom Rini <tr...@ti.com> Cc: Marek Vasut <ma...@denx.de> Signed-off-by: Joel Fernandes <jo...@ti.com> --- v2 changes: - Using DEFINE_CACHE_ALIGN_BUFFER macro for the alignment. - Also fixed alignment for status_req. drivers/usb/gadget/ether.c | 5 +++-- 1 file changed, 3 insertions(+), 2 deletions(-) diff --git a/drivers/usb/gadget/ether.c b/drivers/usb/gadget/ether.c index 579893c..700d5fb 100644 --- a/drivers/usb/gadget/ether.c +++ b/drivers/usb/gadget/ether.c @@ -849,9 +849,10 @@ static struct usb_gadget_strings stringtab = { }; /*============================================================================*/ -static u8 control_req[USB_BUFSIZ]; +DEFINE_CACHE_ALIGN_BUFFER(u8, control_req, USB_BUFSIZ); + #if defined(CONFIG_USB_ETH_CDC) || defined(CONFIG_USB_ETH_RNDIS) -static u8 status_req[STATUS_BYTECOUNT] __attribute__ ((aligned(4))); +DEFINE_CACHE_ALIGN_BUFFER(u8, status_req, STATUS_BYTECOUNT); #endif -- 1.8.1.2 _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot