On 08/29/2013 05:16 AM, Jaehoon Chung wrote:
Hi Przemyslaw,
Could you give me the test-case?
I want to test this problem.
On 08/29/2013 01:49 AM, Przemyslaw Marczak wrote:
According to JEDEC eMMC specification, after data transfer
(multiple or single block) host must wait for card ready
status. This is done by waiting for command and data lines
to be at idle state after transfer. JEDEC does not specify
maximum timeout.
Before this change max timeout was 10 ms but in case of UMS
- when system do multiple read/write operations on random
card blocks - timeout causes I/O errors.
The timeout has been increased to 200ms after data transfer.
For other transfers it stays unchanged.
Tested on Goni and Trats.
Signed-off-by: Przemyslaw Marczak <p.marc...@samsung.com>
Cc: Pantelis Antoniou <pa...@antoniou-consulting.com>
Hello,
You can ease reproduce this problem by typing "ums" on prompt(Trats).
If you are using Goni (without ums config), the problem is hard to
reproduce in this case. Sometimes read one block from mmc just after
start causes error and then you can see information "Controller never
released inhibit bit(s)".
Patch will be completed with some code comment.
Thank you
--
Przemyslaw Marczak
Samsung R&D Institute Poland
Samsung Electronics
p.marc...@samsung.com
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
