On 23/08/13 11:55, Mark Jackson wrote:
> On 23/08/13 11:25, Lokesh Vutla wrote:
>> Hi Mark,
>>
>> On Friday 23 August 2013 02:58 PM, Mark Jackson wrote:
>>> On 30/07/13 06:18, Lokesh Vutla wrote:
>>>> From: Heiko Schocher <h...@denx.de>
>>>>
>>>> s_init has the same outline for all the AM33xx based
>>>> board. So making it generic.
>>>> This also helps in addition of new Soc with minimal changes.
>>>>
>>>> Signed-off-by: Lokesh Vutla <lokeshvu...@ti.com>
>>>> Signed-off-by: Heiko Schocher <h...@denx.de>
>>>> Signed-off-by: Tom Rini <tr...@ti.com>
>>>
>
> <snip>
>
>>> But this fails to boot. However, if I use the old ASM code:-
>>>
>>> void enable_norboot_pin_mux(void)
>>> {
>>> asm("stmfd sp!, {r2 - r4}");
>>> asm("movw r4, #0x8A4");
>>> asm("movw r3, #0x44E1");
>>> asm("orr r4, r4, r3, lsl #16");
>>> asm("mov r2, #9");
>>> asm("mov r3, #8");
>>> asm("gpmc_mux: str r2, [r4], #4");
>>> asm("subs r3, r3, #1");
>>> asm("bne gpmc_mux");
>>> asm("ldmfd sp!, {r2 - r4}");
>>> }
>> This code writes 0x9 into 8 continuous registers starting from
>> 0x44e108a4, this is what done in module_pin_mux norboot_pin_mux
>> except that it has 9 registers(i guess 9th register was added by mistake..:(
>> )
>> Correct me if I am wrong.
>
> Not sure about the code, but it was introduced here:-
>
> http://git.denx.de/?p=u-boot/u-boot-ti.git;a=commit;h=c5c7a7c32d552592ac49749e5c184c89bd50c098
>
>> So you are telling this is wrong but boots properly ?
>
> Basically ... yes !!
Is there any update on this issue ?
I'm keen to get our board support files pushed through.
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
