Hi Albert, On 07/30/2013 02:10 PM, Albert ARIBAUD wrote: >> Add SPL U-Boot support to replace x-loader on the Compulab cm_t35 >> board. Currently only the 256MiB SDRAM board versions are supported. >> >> Tested by booting via MMC and NAND. >> >> Signed-off-by: Stefan Roese <s...@denx.de> >> Cc: Tom Rini <tr...@ti.com> >> Cc: Igor Grinberg <grinb...@compulab.co.il> >> --- >> v3: >> - Some instability of this SDRAM setup has been detected while running >> Linux. Comparison with the x-loader setup showed that mcfg is configured >> slightly differently here. CM_T35 needs RAS-width of 14 instead of >> 13. So use the define MICRON_V_MCFG_200 which implements this 14 >> as RAS width. >> >> v2: > > I assume this means that your request to Tom about PRing V2 is withdrawn > and I can apply his PR as-is. Correct?
Yes. Please go ahead and pull. We can apply this patch at a later time. Thanks, Stefan _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
