From: Fabio Estevam <[email protected]> Currently we have the following behavior in ehci_hcd_init()
- Read csmr1 register, clear bit 26 and then set bit 26. However a little bit later we call set_usb_phy_clk() which clears bit 26, so let's get rid of the unnecessary code. Signed-off-by: Fabio Estevam <[email protected]> --- drivers/usb/host/ehci-mx5.c | 9 --------- 1 file changed, 9 deletions(-) diff --git a/drivers/usb/host/ehci-mx5.c b/drivers/usb/host/ehci-mx5.c index f43c38d..6178a1d 100644 --- a/drivers/usb/host/ehci-mx5.c +++ b/drivers/usb/host/ehci-mx5.c @@ -229,15 +229,6 @@ void __weak board_ehci_hcd_postinit(struct usb_ehci *ehci, int port) int ehci_hcd_init(int index, struct ehci_hccr **hccr, struct ehci_hcor **hcor) { struct usb_ehci *ehci; -#ifdef CONFIG_MX53 - struct clkctl *sc_regs = (struct clkctl *)CCM_BASE_ADDR; - u32 reg; - - reg = __raw_readl(&sc_regs->cscmr1) & ~(1 << 26); - /* derive USB PHY clock multiplexer from PLL3 */ - reg |= 1 << 26; - __raw_writel(reg, &sc_regs->cscmr1); -#endif set_usboh3_clk(); enable_usboh3_clk(1); -- 1.8.1.2 _______________________________________________ U-Boot mailing list [email protected] http://lists.denx.de/mailman/listinfo/u-boot
