Hi Rob, On Wed, 12 Jun 2013 22:24:45 -0500, Rob Herring <[email protected]> wrote:
> From: Rob Herring <[email protected]> > > interrupt_init also sets up the abort stack, but is not setup before > relocation. So any aborts during relocation will hang and not print out > any useful information. Fix this by moving the interrupt_init to after > the stack setup in board_init_f. > > Signed-off-by: Rob Herring <[email protected]> > --- > v2: > - Remove interrupt_init from board_init_r > > arch/arm/lib/board.c | 3 +-- > 1 file changed, 1 insertion(+), 2 deletions(-) > > diff --git a/arch/arm/lib/board.c b/arch/arm/lib/board.c > index 09ab4ad..c90843e 100644 > --- a/arch/arm/lib/board.c > +++ b/arch/arm/lib/board.c > @@ -447,6 +447,7 @@ void board_init_f(ulong bootflag) > addr_sp += 128; /* leave 32 words for abort-stack */ > gd->irq_sp = addr_sp; > #endif > + interrupt_init(); > > debug("New Stack Pointer is: %08lx\n", addr_sp); > > @@ -648,8 +649,6 @@ void board_init_r(gd_t *id, ulong dest_addr) > misc_init_r(); > #endif > > - /* set up exceptions */ > - interrupt_init(); > /* enable exceptions */ > enable_interrupts(); > Whole series applied to u-boot-arm/master, thanks! Amicalement, -- Albert. _______________________________________________ U-Boot mailing list [email protected] http://lists.denx.de/mailman/listinfo/u-boot
