Thanks Stefan, great suggestion, I failed to copy those configurations into
my original message.
/*-----------------------------------------------------------------------
* DDR SDRAM
*----------------------------------------------------------------------*/
#if !defined(CONFIG_NAND_U_BOOT)
#define CONFIG_SPD_EEPROM 1 /* Use SPD
EEPROM for setup */
#define CONFIG_DDR_ECC 1 /* with ECC
support */
/* SPD i2c spd addresses */
#define SPD_EEPROM_ADDRESS {IIC0_DIMM0_ADDR}
#define IIC0_DIMM0_ADDR 0x50
#define IIC0_DIMM1_ADDR 0x52
I am questioning my bus configurations... I haven't hooked up the scope yet,
but I don't think data is hitting the bus. I don't see any areas to
configure the I2C bus besides the board configuration file. Any suggestions?
--
View this message in context:
http://u-boot.10912.n7.nabble.com/PPC4XX-Custom-Board-Failing-to-read-I2C-tp151298p151427.html
Sent from the U-Boot mailing list archive at Nabble.com.
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
