On 08/03/13 09:56, Ramesh K Khokhani wrote: > Hi Friends, > > I have successfully run u-boot our my custom board but I can't run kernel. > Problem is that I have saved uImage.bin at NOR location 0x800000 and load > into DRAM:0x41000000. Here u-boot can get kernel info and print into UART > consol but after loading uncompressed image from 0x41000000 to 0x40020000 > u-boot transfer its control to linux kernel and here my hardware goes reset > means can't run kernel at 0x40020000. > > Following is the log of consol: > > U-Boot 2011.09 (Jan 23 2013 - 17:16:07) > > CPU: BTAM MCF5329 (Mask:54 Version:2) > CPU CLK 240 MHz BUS CLK 80 MHz > Board: BTAM 5329 > I2C: ready > DRAM: 32 MiB > Flash: 16 MiB > In: serial > Out: serial > Err: serial > Net: Link UP timeout > FEC0 > Hit any key to stop autoboot: 5 4 3 2 1 0 > ## Booting kernel from Legacy Image at 41000000 ... > Image Name: > Created: 2013-03-04 12:03:52 UTC > Image Type: M68K Linux Kernel Image (gzip compressed) > Data Size: 1549021 Bytes = 1.5 MiB > Load Address: 40020000 > Entry Point: 40020000 > Verifying Checksum ... OK > Uncompressing Kernel Image ... OK
Once you've got this point, you're no longer in the U-Boot environment. I suggest you repost over on one of the Linux mailing lists. Regards Mark J. _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
