Dear All, I am using u-boot given by our Samsung based s3c2416 board vendor which support SD CARD based boot,I am trying to change the boot command variable adding few more steps to it from the serial console. The problem is I am not able to add all the steps to the bootcmd variable into the environment,it is truncated midway.so can any one share your valuable experience in fixing this issue.
I am trying the below command.. setenv bootcmd "sleep 1;nand scrub ;sleep 1;nand erase;sleep 1;movi read 3800000# 40000 c0000000 ;sleep 1;nand write c0000000 0 40000;sleep 1;movi read kernel c0000000;sleep 1;nand write c0000000 40000 200000;sleep 1;movi read 3600000# 3800000 c0000000 ;sleep 1; nand write.yaffs c0000000 400000 35db4c0; sleep1; movi read 3600000# 3800000 c0000000; nand write.yaffs c0000000 6000000 35db4c0" Thanks in Advance, Ratheendran
_______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
