Dear Luca Ellero, In message <51078bfd.60...@gmail.com> you wrote: > > in U-Boot version 2012.10 I used to skip "relocate_code" setting > CONFIG_SYS_TEXT_BASE to relocaddr (obtained from bdinfo command). > This since some hardware is able to configure SDRAM and load U-Boot > directly to SDRAM, so relocation is useless and time consuming.
You are wrong. relocation is not useless, even in your case. there are quite a number of configuration options that will put stuff above the U-Boot image, directly at the end of RAM (things like protected RAM, shared frame buffer, shared log buffer, etc.). In these cases, the relocation address may even be dynamic (i. e. depending on settings of environment variables, and thus unknown at compile time). > Now I'm using latest git version and this isn't working anymore. > Can someone explain me way? And what is the suggested way to skip > relocation now. Don't. Best regards, Wolfgang Denk -- DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: w...@denx.de The Empire didn't encourage its subjects to go far away, in case they saw things that might disturb them. For the same reason it had built a wall around the entire country, patrolled by the Heavenly Guard whose main function was to tread heavily on the fingers of any inha- bitants who felt they might like to step outside for five minutes for a breath of fresh air. - Terry Pratchett, _Mort_ _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
