From: Gerlando Falauto <[email protected]> If CONFIG_NAND_ECC_BCH is set use 4-bit error correction code instead of the 1-bit error correction code on the NAND device.
Signed-off-by: Gerlando Falauto <[email protected]> Signed-off-by: Holger Brunck <[email protected]> cc: Valentin Longchamp <[email protected]> cc: Prafulla Wadaskar <[email protected]> --- drivers/mtd/nand/kirkwood_nand.c | 4 ++++ 1 files changed, 4 insertions(+), 0 deletions(-) diff --git a/drivers/mtd/nand/kirkwood_nand.c b/drivers/mtd/nand/kirkwood_nand.c index bdab5aa..0a99a10 100644 --- a/drivers/mtd/nand/kirkwood_nand.c +++ b/drivers/mtd/nand/kirkwood_nand.c @@ -74,7 +74,11 @@ void kw_nand_select_chip(struct mtd_info *mtd, int chip) int board_nand_init(struct nand_chip *nand) { nand->options = NAND_COPYBACK | NAND_CACHEPRG | NAND_NO_PADDING; +#if defined(CONFIG_NAND_ECC_BCH) + nand->ecc.mode = NAND_ECC_SOFT_BCH; +#else nand->ecc.mode = NAND_ECC_SOFT; +#endif nand->cmd_ctrl = kw_nand_hwcontrol; nand->chip_delay = 40; nand->select_chip = kw_nand_select_chip; -- 1.7.1 _______________________________________________ U-Boot mailing list [email protected] http://lists.denx.de/mailman/listinfo/u-boot
