Hi Fabio,
On Thursday, January 10, 2013 3:32:25 PM, Fabio Estevam wrote:
> By default, we boot from USDHC3 on mx6qsabresd, so let it be mmc dev
> 0.
>
> Without this fix kernel cannot be retrieved from mmc with the default
> environment.
>
> Signed-off-by: Fabio Estevam <fabio.este...@freescale.com>
> ---
> board/freescale/mx6qsabresd/mx6qsabresd.c | 6 +++---
> 1 file changed, 3 insertions(+), 3 deletions(-)
>
> diff --git a/board/freescale/mx6qsabresd/mx6qsabresd.c
> b/board/freescale/mx6qsabresd/mx6qsabresd.c
> index 65c4a1a..fbcb6cd 100644
> --- a/board/freescale/mx6qsabresd/mx6qsabresd.c
> +++ b/board/freescale/mx6qsabresd/mx6qsabresd.c
> @@ -134,8 +134,8 @@ static void setup_iomux_uart(void)
>
> #ifdef CONFIG_FSL_ESDHC
> struct fsl_esdhc_cfg usdhc_cfg[3] = {
> - {USDHC2_BASE_ADDR},
> {USDHC3_BASE_ADDR},
> + {USDHC2_BASE_ADDR},
> {USDHC4_BASE_ADDR},
> };
>
> @@ -162,13 +162,13 @@ int board_mmc_init(bd_t *bis)
>
> for (i = 0; i < CONFIG_SYS_FSL_USDHC_NUM; i++) {
> switch (i) {
> - case 0:
> + case 1:
> imx_iomux_v3_setup_multiple_pads(
> usdhc2_pads, ARRAY_SIZE(usdhc2_pads));
> gpio_direction_input(USDHC2_CD_GPIO);
> usdhc_cfg[0].sdhc_clk = mxc_get_clock(MXC_ESDHC2_CLK);
^ should be changed to 1 or i
> break;
> - case 1:
> + case 0:
> imx_iomux_v3_setup_multiple_pads(
> usdhc3_pads, ARRAY_SIZE(usdhc3_pads));
> gpio_direction_input(USDHC3_CD_GPIO);
Ditto (with 0 or i) for the following hidden lines.
Best regards,
Benoît
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
