Hi, Albert.
Could you pick-up this patch to your repository?
Best regards,
Nobuhiro
On Thu, Nov 22, 2012 at 7:47 AM, Nobuhiro Iwamatsu
<nobuhiro.iwamatsu...@renesas.com> wrote:
> On Wed, Nov 21, 2012 at 11:29 AM, Tetsuyuki Kobayashi <k...@kmckk.co.jp>
> wrote:
>> After stress test, I found some of kzm9g board occures memory failure.
>> This patch adust SDRAM setting.
>> - Enlarge drivability on both SDRAM controller and SDRAM itself
>> - Raise core voltage
>>
>> Signed-off-by: Tetsuyuki Kobayashi <k...@kmckk.co.jp>
>
> Acked-by: Nobuhiro Iwamatsu <nobuhiro.iwamatsu...@renesas.com>
>
>> ---
>> board/kmc/kzm9g/kzm9g.c | 17 ++++++++++++++---
>> 1 file changed, 14 insertions(+), 3 deletions(-)
>>
>> diff --git a/board/kmc/kzm9g/kzm9g.c b/board/kmc/kzm9g/kzm9g.c
>> index 54f25e0..1aeb5fe 100644
>> --- a/board/kmc/kzm9g/kzm9g.c
>> +++ b/board/kmc/kzm9g/kzm9g.c
>> @@ -84,7 +84,7 @@ static void sbsc_init(struct sh73a0_sbsc *sbsc)
>> writel(0x0017040a, &sbsc->sdwcr01);
>> writel(0x31020707, &sbsc->sdwcr10);
>> writel(0x0017040a, &sbsc->sdwcr11);
>> - writel(0x05555555, &sbsc->sddrvcr0);
>> + writel(0x055557ff, &sbsc->sddrvcr0); /* Enlarge drivability of
>> LPDQS0-3, LPCLK */
>> writel(0x30000000, &sbsc->sdwcr2);
>>
>> writel(readl(&sbsc->sdpcr) | 0x80, &sbsc->sdpcr);
>> @@ -112,7 +112,7 @@ static void sbsc_init(struct sh73a0_sbsc *sbsc)
>> writel(0x0, SDMRA1A);
>> writel(0x00000402, &sbsc->sdmracr0);
>> writel(0x0, SDMRA1A);
>> - writel(0x00000403, &sbsc->sdmracr0);
>> + writel(0x00000203, &sbsc->sdmracr0); /* MR3 register DS=2 */
>> writel(0x0, SDMRA1A);
>> writel(0x0, SDMRA2A);
>> } else {
>> @@ -120,7 +120,7 @@ static void sbsc_init(struct sh73a0_sbsc *sbsc)
>> writel(0x0, SDMRA1B);
>> writel(0x00000402, &sbsc->sdmracr0);
>> writel(0x0, SDMRA1B);
>> - writel(0x00000403, &sbsc->sdmracr0);
>> + writel(0x00000203, &sbsc->sdmracr0); /* MR3 register DS=2 */
>> writel(0x0, SDMRA1B);
>> writel(0x0, SDMRA2B);
>> }
>> @@ -301,8 +301,19 @@ int board_early_init_f(void)
>> return 0;
>> }
>>
>> +void adjust_core_voltage(void)
>> +{
>> + u8 data;
>> +
>> + i2c_init(CONFIG_SYS_I2C_SPEED, CONFIG_SYS_I2C_SLAVE);
>> + data = 0x35;
>> + i2c_set_bus_num(0);
>> + i2c_write(0x40, 3, 1, &data, 1);
>> +}
>> +
>> int board_init(void)
>> {
>> + adjust_core_voltage();
>> sh73a0_pinmux_init();
>>
>> /* SCIFA 4 */
>> --
>> 1.7.9.5
>>
>> _______________________________________________
>> U-Boot mailing list
>> U-Boot@lists.denx.de
>> http://lists.denx.de/mailman/listinfo/u-boot
>
>
>
> --
> Nobuhiro Iwamatsu
--
Nobuhiro Iwamatsu
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
