Hello,
I am sorry if this is a question that has been answered before. It is just that the entire project is overwhelming right now. So I will ask for some guidance. I need to write/port a bootloader to start a Xilinx virtex5 PPC. It is going to be running on a custom FPGA. I am not really sure where I begin, what files to create, modify, configure, etc... I do have a problem that I am not sure is obviously resolvable. I will packaging the bootloader with the FPGA firmware files, they will be written into the BRAM via a PCI bus. The problem is that the MAC address will not be resolved until the bootloader/firmware package has been made. Is there a way that I could write this value (via script?) after the load? Maybe I just don't understand the ways that the MAC address can be written. Thanks for any help you can give! I understand that I am asking a large general question, but I need some help finding the right road. :: Ryan Neal Office: 490/279 Phone: 408.774.2747
_______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot