Clock pin must have input enabled for MMC3 to work.
Also enable pull-ups for cmd/data lines to be consistent
with remaining MMC host pin setup.
Signed-off-by: Grazvydas Ignotas <nota...@gmail.com>
---
Changes in v2:
No patch changes, update git commit message above.
board/omap3/pandora/pandora.h | 12 ++++++------
1 file changed, 6 insertions(+), 6 deletions(-)
Index: u-boot-main/board/omap3/pandora/pandora.h
===================================================================
--- u-boot-main.orig/board/omap3/pandora/pandora.h
+++ u-boot-main/board/omap3/pandora/pandora.h
@@ -199,12 +199,12 @@ const omap3_sysinfo sysinfo = {
MUX_VAL(CP(MMC2_DAT7), (IEN | PTU | EN | M1)) /*MMC2_CLKIN*/\
MUX_VAL(CP(MMC1_DAT5), (IEN | PTD | DIS | M4)) /*GPIO_127 -
MMC2_WP*/\
/*SDIO Interface to WIFI Module*/\
- MUX_VAL(CP(ETK_CLK_ES2), (IDIS | PTU | EN | M2)) /*MMC3_CLK*/\
- MUX_VAL(CP(ETK_CTL_ES2), (IEN | PTD | DIS | M2)) /*MMC3_CMD*/\
- MUX_VAL(CP(ETK_D4_ES2), (IEN | PTD | DIS | M2)) /*MMC3_DAT0*/\
- MUX_VAL(CP(ETK_D5_ES2), (IEN | PTD | DIS | M2)) /*MMC3_DAT1*/\
- MUX_VAL(CP(ETK_D6_ES2), (IEN | PTD | DIS | M2)) /*MMC3_DAT2*/\
- MUX_VAL(CP(ETK_D3_ES2), (IEN | PTD | DIS | M2)) /*MMC3_DAT3*/\
+ MUX_VAL(CP(ETK_CLK_ES2), (IEN | PTD | DIS | M2)) /*MMC3_CLK*/\
+ MUX_VAL(CP(ETK_CTL_ES2), (IEN | PTU | EN | M2)) /*MMC3_CMD*/\
+ MUX_VAL(CP(ETK_D4_ES2), (IEN | PTU | EN | M2)) /*MMC3_DAT0*/\
+ MUX_VAL(CP(ETK_D5_ES2), (IEN | PTU | EN | M2)) /*MMC3_DAT1*/\
+ MUX_VAL(CP(ETK_D6_ES2), (IEN | PTU | EN | M2)) /*MMC3_DAT2*/\
+ MUX_VAL(CP(ETK_D3_ES2), (IEN | PTU | EN | M2)) /*MMC3_DAT3*/\
/*Audio Interface To Bluetooth chip*/\
MUX_VAL(CP(MCBSP3_DX), (IDIS | PTD | DIS | M0)) /*McBSP3_DX*/\
MUX_VAL(CP(MCBSP3_DR), (IEN | PTD | DIS | M0)) /*McBSP3_DR*/\
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
