Previously, waiting for auto-negotiation would only occur if a valid
link had been detected. Problems arose when attempting to use a
tsec immediately after bootup but before link was achieved, eg:
=> dhcp
Auto-neg error, defaulting to 10BT/HD
eTSEC1: No link.
Auto-neg error, defaulting to 10BT/HD
eTSEC2: No link.
=>
With this patch applied the same operation as above resulted in:
=> dhcp
Waiting for PHY auto negotiation to complete. done
Enet starting in 1000BT/FD
Speed: 1000, full duplex
Signed-off-by: Peter Tyser <pty...@xes-inc.com>
---
drivers/net/tsec.c | 19 +++++++++----------
1 files changed, 9 insertions(+), 10 deletions(-)
diff --git a/drivers/net/tsec.c b/drivers/net/tsec.c
index dc90f23..2e30fe9 100644
--- a/drivers/net/tsec.c
+++ b/drivers/net/tsec.c
@@ -352,8 +352,8 @@ uint mii_cr_init(uint mii_reg, struct tsec_private * priv)
return MIIM_CR_INIT;
}
-/* Parse the status register for link, and then do
- * auto-negotiation
+/*
+ * Wait for auto-negotiation to complete, then determine link
*/
uint mii_parse_sr(uint mii_reg, struct tsec_private * priv)
{
@@ -362,8 +362,7 @@ uint mii_parse_sr(uint mii_reg, struct tsec_private * priv)
* (ie - we're capable and it's not done)
*/
mii_reg = read_phy_reg(priv, MIIM_STATUS);
- if ((mii_reg & MIIM_STATUS_LINK) && (mii_reg & PHY_BMSR_AUTN_ABLE)
- && !(mii_reg & PHY_BMSR_AUTN_COMP)) {
+ if ((mii_reg & PHY_BMSR_AUTN_ABLE) && !(mii_reg & PHY_BMSR_AUTN_COMP)) {
int i = 0;
puts("Waiting for PHY auto negotiation to complete");
@@ -384,15 +383,15 @@ uint mii_parse_sr(uint mii_reg, struct tsec_private *
priv)
mii_reg = read_phy_reg(priv, MIIM_STATUS);
}
puts(" done\n");
- priv->link = 1;
+
+ /* Link status bit is latched low, read it again */
+ mii_reg = read_phy_reg(priv, MIIM_STATUS);
+
udelay(500000); /* another 500 ms (results in faster booting) */
- } else {
- if (mii_reg & MIIM_STATUS_LINK)
- priv->link = 1;
- else
- priv->link = 0;
}
+ priv->link = mii_reg & MIIM_STATUS_LINK ? 1 : 0;
+
return 0;
}
--
1.6.0.2.GIT
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
