Dear "Ryan J M", In message <[email protected]> you wrote: > I thought it would be better to check whether chip->ecc.size equal 0 > here, I forgot to set ecc.size in board_nand_init() and it trigs a > div0 hang. > > driver/mtd/nand/nand_base.c > 2786 /* > 2787 * Set the number of read / write steps for one page > depending on ECC > 2788 * mode > 2789 */ > 2790 chip->ecc.steps = mtd->writesize / chip->ecc.size; > 2791 if(chip->ecc.steps * chip->ecc.size != mtd->writesize) { > 2792 printk(KERN_WARNING "Invalid ecc parameters\n"); > 2793 BUG(); > 2794 } > 2795 chip->ecc.total = chip->ecc.steps * chip->ecc.bytes; > 2796
Please submit a proper patch - see http://www.denx.de/wiki/U-Boot/Patches for instructions. Best regards, Wolfgang Denk -- DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: [email protected] Q: Do you know what the death rate around here is? A: One per person. _______________________________________________ U-Boot mailing list [email protected] http://lists.denx.de/mailman/listinfo/u-boot
