From: Karl Beldan <[EMAIL PROTECTED]>
Some chips require a RESET after power-up (e.g. Micron MT29FxGxxxxx).
The first command sent is NAND_CMD_READID.
Issue a NAND_CMD_RESET in nand_scan_ident before reading the device id.
Tested with an MT29F4G08AAC.
Signed-off-by: Karl Beldan <[EMAIL PROTECTED]>
Signed-off-by: Scott Wood <[EMAIL PROTECTED]>
---
Applied to u-boot-nand-flash
drivers/mtd/nand/nand_base.c | 8 ++++++++
1 files changed, 8 insertions(+), 0 deletions(-)
diff --git a/drivers/mtd/nand/nand_base.c b/drivers/mtd/nand/nand_base.c
index 4069ab1..ba05b76 100644
--- a/drivers/mtd/nand/nand_base.c
+++ b/drivers/mtd/nand/nand_base.c
@@ -2450,6 +2450,12 @@ static struct nand_flash_dev *nand_get_flash_type(struct
mtd_info *mtd,
/* Select the device */
chip->select_chip(mtd, 0);
+ /*
+ * Reset the chip, required by some chips (e.g. Micron MT29FxGxxxxx)
+ * after power-up
+ */
+ chip->cmdfunc(mtd, NAND_CMD_RESET, -1, -1);
+
/* Send the command for reading device ID */
chip->cmdfunc(mtd, NAND_CMD_READID, 0x00, -1);
@@ -2620,6 +2626,8 @@ int nand_scan_ident(struct mtd_info *mtd, int maxchips)
/* Check for a chip array */
for (i = 1; i < maxchips; i++) {
chip->select_chip(mtd, i);
+ /* See comment in nand_get_flash_type for reset */
+ chip->cmdfunc(mtd, NAND_CMD_RESET, -1, -1);
/* Send the command for reading device ID */
chip->cmdfunc(mtd, NAND_CMD_READID, 0x00, -1);
/* Read manufacturer and device IDs */
--
1.5.6.rc1.6.gc53ad
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
