On Thu, 23 Oct 2008, Wolfgang Denk wrote: > Dear Guennadi Liakhovetski, > > In message <[EMAIL PROTECTED]> you wrote: > > > > > > + /* Xm0CSn[2] = OneNANDC CS0 or NFCON CS0, Xm0CSn[3] = SROMC CS3 > > > > */ > > > > > > Right, and also add OneNAND & NFCON is depends on XNANDSEL. > > > > In the datasheet this signal is called XSELNAND. And I don't think we have > > to quote this in the comment. This is a hardware configuration issue, not > > software, and we are not explaining the complete NAND configuration here, > > otherwise we would have to mention OM signals too, maybe more. > > Hey, actually I do think that describing which hardware configurations > the software performs is a Good Thing (TM).
Exactly, "which hardware configurations the software performs", XSELNAND is not performed in software, this is just a pin you wire high or low on your board. That's why I said we might not need to comment upon it. That's how I interpreted the datasheet anyway. Thanks Guennadi --- Guennadi Liakhovetski, Ph.D. DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-0 Fax: +49-8142-66989-80 Email: [EMAIL PROTECTED] _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
