Hi Kevin, Kevin Greer a écrit : > I am working with a custom board based on the Atmel at91sam9260 arm > processor with a Micrel 2 Gb Nand flash chip (mt29f2g08aadwp). However, > when u-boot starts it reports the wrong Chip ID (0x01 instead of 0xda) and > then I start getting Bad eraseblock messages during the rest of the boot > process. The strange thing is that when I debug the board using a JTAG it > gets the correct Chip ID and boots properly. I am hoping that someone else > might have run into a similar problem, or might have an idea of how to > proceed. > try sending a reset command to the nand before getting the ID, this should solve the problem.
Eric _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
