Hello, I am having problem when I try to bootup MPC8360EMDS with Uboot1.2. The following are logs. The board reboot when the uboot tried to run on the RAM. Any idea on this issue?
Thanks, Mike U-Boot 1.2.1 (Sep 23 2008 - 14:35:42) MPC83XX Clock configuration: Coherent System Bus: 264 MHz Core: 528 MHz QE: 396 MHz Local Bus Controller: 264 MHz Local Bus: 66 MHz DDR: 264 MHz DDR Secondary: 264 MHz SEC: 88 MHz I2C1: 264 MHz I2C2: 264 MHz CPU: MPC8360E, Rev: 21 at 528 MHz Board: Freescale MPC8360EMDS I2C: ready DRAM: cs0_bnds = 0x0000000f cs0_config = 0x80000102 DDR:bar=0x00000000 DDR:ar=0x8000001b DDR:Module maximum data rate is: 400Mhz DDR:Effective data rate is: 266Mhz DDR:The MSB 1 of CAS Latency is: 4 Errata DDR6 (debug_reg=0x002c0000) DDR:timing_cfg_1=0x37353321 DDR:timing_cfg_2=0x00000800 DDR DIMM: data bus width is 64 bit with ECC DDR:sdram_mode=0x00000032 DDR:sdram_interval=0x045b0100 DDR:sdram_clk_cntl=0x00000000 DDRC ECC mode: OFF DDR:sdram_cfg=0xc2000000 SDRAM on Local Bus: 64 MB DDR RAM: 256 MB Top of RAM usable for U-Boot at: 10000000 Reserving 205k for U-Boot at: 0ffcc000 Reserving 136k for malloc() at: 0ffaa000 Reserving 76 Bytes for Board Info at: 0ffa9fb4 Reserving 104 Bytes for Global Data at: 0ffa9f4c Stack Pointer at: 0ffa9f28 _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
