Hello Stelian, Thanks for the logging. This is useful info.
> usb_control_msg: request: 0x1, requesttype: 0x23, value 0x14 index 0x1 length > 0x0 > New Device 1 > usb_control_msg: request: 0x6, requesttype: 0x80, value 0x100 index 0x0 > length 0x40 > ERROR: USB-error: DEVICENOTRESPONDING: Device did not respond to token (IN) > or did > not provide a handshake (OUT) (5) Apparently the 1st access to the device already fails. Can you please try to set "#define CONFIG_LEGACY_USB_INIT_SEQ 1" in your include/configs/<board>.h ? This enables the old way U-boot does the device initialisation. If this helps I have to check 1 of my patches, which changed this behaviour to make it compliant to the USB standard. The legacy implementation of U-boot is just wrong, but it might work. Kind Regards, Remy > ERROR: USB-error: DEVICENOTRESPONDING: Device did not respond to token (IN) > or did > not provide a handshake (OUT) (5) > usb_new_device: 64 byte descr > usb_control_msg: request: 0x3, requesttype: 0x23, value 0x4 index 0x1 length > 0x0 > usb_control_msg: request: 0x0, requesttype: 0xA3, value 0x0 index 0x1 length > 0x4 > usb_control_msg: request: 0x1, requesttype: 0x23, value 0x14 index 0x1 length > 0x0 > set address 2 > usb_control_msg: request: 0x5, requesttype: 0x0, value 0x2 index 0x0 length > 0x0 > ERROR: submit_control_message: pipesize for pipe 80000000 is zero > > USB device not accepting new address (error=80000000) > usb_control_msg: request: 0x1, requesttype: 0x23, value 0x1 index 0x1 length > 0x0 > usb_control_msg: request: 0x0, requesttype: 0xA3, value 0x0 index 0x2 length > 0x4 > 2 USB Device(s) found > scanning bus for storage devices... 0 Storage Device(s) found > U-Boot> > -- > Stelian Pop <[EMAIL PROTECTED]> > > _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
