Dear Matthias Fuchs, In message <[EMAIL PROTECTED]> you wrote: > > I noticed some strange CTRL-C behavior in a BSP command. > When I run my bsp command interactively everything is fine. ... > But when I call this bsp command as bootcmd CTRL-C does not stop the while > loop. So CTRL-C > is not detected. Any idea?
Do you happen to have CONFIG_AUTOBOOT_KEYED set in your board configuration? Best regards, Wolfgang Denk -- DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: [EMAIL PROTECTED] Program maintenance is an entropy-increasing process, and even its most skilfull execution only delays the subsidence of the system into unfixable obsolescence. - Fred Brooks, "The Mythical Man Month" _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
