[U-Boot] [PATCH 2/3] mpc83xx: add PCISLAVE support to 83XX_GENERIC_PCI setup code

[Ira W. Snyder]

This adds a helper function to unlock the PCI configuration bit, so that
any extra PCI setup (such as outbound windows, etc.) can be done after
using the 83XX_GENERIC_PCI code to set up the PCI bus.

Signed-off-by: Ira W. Snyder <[EMAIL PROTECTED]>
---
 cpu/mpc83xx/pci.c |   26 ++++++++++++++++++++++++++
 1 files changed, 26 insertions(+), 0 deletions(-)

diff --git a/cpu/mpc83xx/pci.c b/cpu/mpc83xx/pci.c
index adabf7a..c3ec5f8 100644
--- a/cpu/mpc83xx/pci.c
+++ b/cpu/mpc83xx/pci.c
@@ -167,6 +167,32 @@ void mpc83xx_pci_init(int num_buses, struct pci_region 
**reg, int warmboot)
                pci_init_bus(i, reg[i]);
 }
 
+#ifdef CONFIG_PCISLAVE
+
+#define PCI_FUNCTION_CONFIG    0x44
+#define PCI_FUNCTION_CFG_LOCK  0x20
+
+/*
+ * Unlock the configuration bit so that the host system can begin booting
+ *
+ * This should be used after you have:
+ * 1) Called mpc83xx_pci_init()
+ * 2) Set up your inbound translation windows to the appropriate size
+ */
+void mpc83xx_pcislave_unlock(int bus)
+{
+       struct pci_controller *hose = &pci_hose[bus];
+       u32 dev;
+       u16 reg16;
+
+       /* Unlock configuration lock in PCI function configuration register */
+       dev = PCI_BDF(hose->first_busno, 0, 0);
+       pci_hose_read_config_word (hose, dev, PCI_FUNCTION_CONFIG, &reg16);
+       reg16 &= ~(PCI_FUNCTION_CFG_LOCK);
+       pci_hose_write_config_word (hose, dev, PCI_FUNCTION_CONFIG, reg16);
+}
+#endif
+
 #if defined(CONFIG_OF_LIBFDT)
 void ft_pci_setup(void *blob, bd_t *bd)
 {
-- 
1.5.4.3

_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot