I'm not sure how TOR gets its addresses but sometimes you need to
specify it directly, especially for bridges for some reason. Just use
your whole IP
ORPort 123.456.789.123:80
Dont forget if you are mapping Obfs4 you need to add the permissions so
obfs can go to a port that low
/Don't forget to change the |ORPort|, |ServerTransportListenAddr|,
|ContactInfo|, and |Nickname| options./
//
*
/If you decide to use a fixed obfs4 port smaller than 1024 (for
example 80 or 443), you will need to give obfs4
|CAP_NET_BIND_SERVICE| capabilities to bind the port with a
non-root user:/
/|sudo setcap cap_net_bind_service=+ep /usr/bin/obfs4proxy|/
/To work around systemd hardening, you will also need to set
|NoNewPrivileges=no| in
|/lib/systemd/system/tor@default.service| and
|/lib/systemd/system/tor@.service| and then run |systemctl
daemon-reload|. For more details, see ticket 18356
<https://gitlab.torproject.org/tpo/core/tor/-/issues/18356>./
*
/Note that both Tor's OR port and its obfs4 port must be
reachable. If your bridge is behind a firewall or NAT, make sure
to open both ports. You can use our reachability test
<https://bridges.torproject.org/scan/> to see if your obfs4 port
is reachable from the Internet./
On 2/15/2021 3:00 PM, Anonforpeace wrote:
Hello:
Am trying to configure my bridge according to instructions on Tor
site. Using Ubuntu. No matter what port I pick for the ORPort I keep
getting this error:
Unable to find IPv4 address for ORPort 80. You might want to specify
IPv4Only to it or set an explicit address or set Address.
Have never seen this before. Please help.
Thanks
_______________________________________________
tor-relays mailing list
tor-relays@lists.torproject.org
https://lists.torproject.org/cgi-bin/mailman/listinfo/tor-relays
_______________________________________________
tor-relays mailing list
tor-relays@lists.torproject.org
https://lists.torproject.org/cgi-bin/mailman/listinfo/tor-relays
