Hi Steve,
I watched the video and at the 13:50 mark it says to "sweep just the raw
driven element without any hairpin, LC networks, ununs, stubs, or
anything used to match the coax, just connect the analyzer to the bare
element". That makes total sense for series-fed driven element. However,
for a shunt-fed driven element what is the procedure? Do you first
adjust the shunt-feed for a low VSWR at the design frequency with the
all the parasitic elements open at the base and then subsequently follow
the procedure that you describe in the video? Does the procedure still
work if the series gamma capacitor in the shunt-feed is present?
73, Mike W4EF....................
On 7/20/2026 5:06 PM, VE6WZ Steve via Topband wrote:
Hi Mike,
The K3LR type array is just a vertical 3 el parasitic array. Driver, reflector
and director. The driven element can be a shunt fed grounded tower. It just
provides the drive to the two parasitics. Think of a shunt fed tower driver
like a gamma matched (shunt fed) driver in a typical horizontal Yagi. Same
thing.
I made a video that explains a method for turning a parasitic array, both a 2
element or a three element. I talk about how mutual coupling gives us the info
we need to adjust the parasitics for max gain or F/B. Even using a shunt fed
tower:
https://youtu.be/J8S3iZ9-848
Steve VE6WZ
From Babcocks iPhone
On Jul 20, 2026, at 5:09 PM, Michael Tope <[email protected]> wrote:
Thanks, Mirko. I found this video briefly describing Steve's 160 Tx Array with
the shunt-fed driven element as it existed before the lift-cable on the
crank-up tower broke:
https://www.youtube.com/watch?v=VXDTEj0xDJU
I don't know if Steve just cranked down the tower when adjusting the resonant
frequency of the parasitic elements, or whether he left the tower-up and
detuned it somehow. He doesn't really get into that in the video.
There is a google drive link below the YouTube video to a paper describing the
the array, but the link doesn't seem to work.
73, Mike W4EF....................
On 7/20/2026 6:47 AM, S57AD via Topband wrote:
Mike, if I recall correctly, VE6WZ uses 160m parasitic array with shunt feed
tower.
73 Mirko, S57AD
V V pon., 20. jul. 2026 ob 14:04 je oseba Michael Tope <[email protected]>
napisala:
Tim,
I am curious, is there any reason why the center tower in that array of
yours could not be shunt-fed? I suppose that might require de-tuning the
tower in order to adjust the parasitic elements, whereas with a base
insulated tower you could just open-circuit the driven elements.
Do you know of anyone who has made this sort of array work with a
shunt-fed tower as the primary support?
73, Mike W4EF............
On 7/19/2026 11:22 PM, Tim Duffy wrote:
Speaking of base fed insulated towers on 160... that happen to be 90
degrees
high (about 120 feet) - by design... I have had this for over 30 years -
it
_________________
Searchable Archives: http://www.contesting.com/_topband - Topband Reflector
_________________
Searchable Archives: http://www.contesting.com/_topband - Topband Reflector
_________________
Searchable Archives: http://www.contesting.com/_topband - Topband Reflector
