On 01/16/2013 10:22 AM, Wayne Willenberg wrote:
I have been looking on the Internet, and one possible solution is Array Solutions Model AS-RXFEP, RF Front End Protector. The advertising claims to protect in the feedback situation as well as in a lightning situation. The insertion loss is claimed to be only 0.3dB. For only $55 this seems like a good investment. Does anyone have experience with this unit or would you please suggest an alternative?
You can build a near-equivalent to this yourself. You want two series of 4 or 5 schottky diodes between the signal and ground, in opposite sign to each other. This limits the maximum voltage across the radio's signal input to 2V or so. Secondly, you want to limit how much current flows through the diodes, so they are protected. You can do that by having a 5 to 10 ohm resistor in series with your signal, between the beverage antenna and the point where you have the diodes to clip the signal. That will limit the current to a small enough amount that the diodes should not get damaged, and the voltage should not go up just because there is a higher current flowing through the diodes. If you want to protect this circuit from higher potential discharges (eg. nearby lightning strikes), you can always put a TV coax gas discharge tube protection device between your the antenna and diodes+resistor circuit. Another solution is to have a relay that switches your beverage in and out, based on one of the signals put out by your radio when it receives (or transmits). Chances are the amplifier or transverter control port on your radio will have a suitable signal. _________________ Topband Reflector
