I’m planning to put up an inverted-L, using twinlead (akin to half a folded dipole – some folks call it a folded unipole). Modeling suggests that the feedpoint impedance will be about 100 ohms, so I plan to match with a quarter-wave section of 75 ohm coax.
I’ve read Rudy Severns’ Jan/Feb 2009 QEX article ( http://rudys.typepad.com/files/qex-ground-systems-part-2.pdf ) which indicates that, with a small number of above-ground radials (e.g., less than 16), radials shorter than a quarter-wave are preferred. (I plan to use 8 one-eighth wavelength radials.) Rudy also notes the advantage, in some instances, of ground rods. A six foot ground rod doesn’t have much surface area (about 150 sq inches). I have some leftover copper strap, and am considering burying it (e.g., 6 inches underground) to augment the grounding. My question is – where is it best used? A three foot length of four inch strap has a surface area of nearly 300 sq inches. If I have 12 feet of strap, would it be better to bury all of it at the feedpoint? Or would it be better to cut it, e.g., into 3 foot lengths, and bury one piece at feedpoint, and the other three at radially-spaced locations, e.g., ten feet out (and wired to ground system)? (Since return current density decreases with square of distance, there doesn’t seem much point in burying them way out towards the periphery.) Can anyone point to published data about placement of multiple ground rods/connections? Tnx, Bill, K2PO _______________________________________________ UR RST IS ... ... ..9 QSB QSB - hw? BK
