> Has anyone else had problems with > WD1A breaking? I plan to try a 2 wire bev using the WD1A but if > is troublesome I may opt for something else.
I have not had any problems with WD1A but those steel strands which give it strength will rust quickly and eventually break if water gets to them. Seal the ends so water cannot get in! I put crimp connectors (the type with plastic on the back) on the ends of mine. Crimp lightly, then solder, then with the new connector dangling vertically, fill the back of it where the wire comes out with Krazy Glue, wait for it to set. No water can get to the wire if done properly. No doubt there are dozens of other ways to seal it. 73, Paul N1BUG _______________________________________________ UR RST IS ... ... ..9 QSB QSB - hw? BK
