On Sat, Oct 5, 2013 at 5:37 AM, student COEP <[email protected]>wrote:
> I am using micaz platform and I have used the drivers of cc2420. Instead > of connecting the cc2420, I used cc2520. > Okay... and how did you switch the 2420 out for the 2520? If you change the hw, it effectively becomes a different platform. the 2520 is different than the 2420. The 2520 does have a 2420 compatibility mode but I'm not sure how well it works. > Can I use cc2520 instead of cc2420? > The existing cc2520 driver was done for the sam (cortex) processors. So I seriously doubt it will work with the micaz. So bottom line is I seriously doubt what you are trying to do will work. > > > On 5 October 2013 00:44, Eric Decker <[email protected]> wrote: > >> >> where did you get a cc2520 driver from? What platform are you using? >> >> if the radio doesn't work, the leds won't do anything because you have to >> be able to receive a message to change the LEDs. >> >> >> On Fri, Oct 4, 2013 at 3:37 AM, student COEP <[email protected]>wrote: >> >>> Hello all, >>> i am using a cc2520 radio instead of cc2420 on micaz platform, i burned >>> the code for the BlinkToRadio tutorial on 2 motes but the Leds on both the >>> nodes remain high, why is it happening so? >>> >>> Thank You. >>> >>> _______________________________________________ >>> Tinyos-help mailing list >>> [email protected] >>> https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help >>> >> >> >> >> -- >> Eric B. Decker >> Senior (over 50 :-) Researcher >> >> > -- Eric B. Decker Senior (over 50 :-) Researcher
_______________________________________________ Tinyos-help mailing list [email protected] https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
