thx, Janos.
I used the following low level calls to make it work:
cli();
PORTD = PORTD | 0x03;
sei();
For you suggestion, I guess it is like
SensorP.IO0 -> HplAtm128GeneralIOC.PortE0; // SCL
SensorP.IO1 -> HplAtm128GeneralIOC.PortE1; // SDA
However, I don't quite understand what the following calls do:
call IO.makeInput();
call IO.set(); // is it high or low
Call IO.set(1) leads to compiling error.
________________________________________
From: [email protected] [[email protected]] on behalf of Janos Sallai
[[email protected]]
Sent: Thursday, 29 August, 2013 9:22:24 PM
To: He Dajiang (I2R)
Cc: [email protected]
Subject: Re: [Tinyos-help] IO configuration
The best way to go is wiring the PortD interface of GeneralIOC, and
using the commands of the interface to get/set the levels and
directions of the pins.
Janos
On Thu, Aug 29, 2013 at 4:23 AM, He Dajiang (I2R)
<[email protected]> wrote:
> Hi,
>
> For Micaz, what is the proper call to pull up the following two pins:
>
> PORTD0 and PORTD1
>
> Is it SET_BIT(PORTD, 0x03)?
>
> Best Regards
>
> Institute for Infocomm Research disclaimer: "This email is confidential and
> may be privileged. If you are not the intended recipient, please delete it
> and notify us immediately. Please do not copy or use it for any purpose, or
> disclose its contents to any other person. Thank you."
>
> _______________________________________________
> Tinyos-help mailing list
> [email protected]
> https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
>
Institute for Infocomm Research disclaimer: "This email is confidential and
may be privileged. If you are not the intended recipient, please delete it and
notify us immediately. Please do not copy or use it for any purpose, or
disclose its contents to any other person. Thank you."
_______________________________________________
Tinyos-help mailing list
[email protected]
https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
