It is very unlikely that you will get an answer to this question. typically, this is an engineering problem that you need to evaluate and make decisions on your own.
Given that you are doing essentially new hardware you should probably not use these older CPUs. If I were doing this project, I would go with the msp430f5438a because of its low power as well as its rich i/o system. It has lots of ports. You will need to figure everything else out. On Wed, Apr 3, 2013 at 7:00 AM, Faruk Baturalp Günay < [email protected]> wrote: > Hello all, > > I have Telosb and MICAz motes,i'm planning to connect 3 axis > accelerometer,magnetometer and high accuracy (<1m) GPS receiver to those > nodes.Which one of these nodes can be useful for connections,and which > expansion ports i should use for mentioned connections?Moreover can you > suggest some accelerometers,magnetometers and high accuracy GPS receiver > which are appropriate or you used.Thank you from now. > > > _______________________________________________ > Tinyos-help mailing list > [email protected] > https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help > -- Eric B. Decker Senior (over 50 :-) Researcher
_______________________________________________ Tinyos-help mailing list [email protected] https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
