The app was written for telosb, which has more RAM (so on micaz you might have to reduce the number of queue entries, because it seems like you're getting too close to the 4 K bytes of RAM).
Jan On Wed, Sep 19, 2012 at 10:10 AM, Felipe Cruz Martínez <[email protected]> wrote: > Hi, > > i have made an application based in the “packetsniffer” of TKN 15.4 (located > in /opt/tinyos-2.x/apps/tests/tkn154). > That application has been installed in a micaz mote, which is connected > through serial port (that device acts as a base station). > > Other devices send data frames to the base station, and i would like send > the content of the payload of that frames to the serial port. > But i’ve got the following problem: > > When i create a new Queue component: > > components new QueueC(message_t*, RX_QUEUE_SIZE); > > By default RX_QUEUE_SIZE take a value of 10 in the “app_profile.h” of the > packetsniffer app. However, when i made my own application, if the > RX_QUEUE_SIZE take values higher than 6, it crashes (Boot.booted never is > signaled). I think that it is due to a memory problem, but i’m not sure. > > To make matters help, i attach the output: > > $> make micaz install,1 mib520,/dev/ttyUSB0 > (....) > compiled coordinatorAppC to build/micaz/main.exe > 37128 bytes in ROM > 3489 bytes in RAM > avr-objcopy --output-target=srec build/micaz/main.exe build/micaz/main.srec > avr-objcopy --output-target=ihex build/micaz/main.exe build/micaz/main.ihex > writing TOS image > tos-set-symbols build/micaz/main.srec build/micaz/main.srec.out-1 > TOS_NODE_ID=1 ActiveMessageAddressC__addr=1 > Could not find symbol ActiveMessageAddressC__addr in build/micaz/main.exe, > ignoring symbol. > installing micaz binary using mib510 > uisp -dprog=mib510 -dserial=/dev/ttyUSB0 --wr_fuse_h=0xd9 -dpart=ATmega128 > --wr_fuse_e=ff --erase --upload if=build/micaz/main.srec.out-1 --verify > Firmware Version: 1.8 > Atmel AVR ATmega128 is found. > Uploading: flash > Verifying: flash > > Fuse High Byte set to 0xd9 > > Fuse Extended Byte set to 0xff > rm -f build/micaz/main.exe.out-1 build/micaz/main.srec.out-1 > > -------------------------------------------------------------------------------------------------- > > Any help would be very appreciated. > Thanks in advance, > Felipe. > > > > _______________________________________________ > Tinyos-help mailing list > [email protected] > https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help _______________________________________________ Tinyos-help mailing list [email protected] https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
