With this patch I pushed on mod:
diff --git a/configure b/configure
index 73f5e02..d135959 100755
--- a/configure
+++ b/configure
@@ -159,6 +159,18 @@ for opt do
esac
done
+# don't strip unless --strip-binaries is specified.
+# "make install-strip" still strips.
+case $"conftest" in
+ *strip=*)
+ # strip is set (to yes) keep it.
+ ;;
+ *)
+ # strip is not set, set it to no => CONFIG_strip=no
+ confvars="$confvars strip=no"
+ ;;
+esac
+
cc="${cross_prefix}${cc}"
ar="${cross_prefix}${ar}"
strip="${cross_prefix}${strip}"
config.mak correctly sets "CONFIG_strip=no" which is then use compare with
"no" in Makefile.
The change you may see is that default tcc build is bigger (not stripped)
which is expected.
To strip, either use -strip-binaries or install with "make install-strip"
C.
From: Tinycc-devel [mailto:[email protected]]
On Behalf Of Christian Jullien
Sent: Sunday, January 10, 2021 06:01
To: [email protected]
Subject: [Tinycc-devel] BUG "make install" always strips
Hi,
Porting tcc on OpenBSD, I discovered that "make install" always strips the
tcc binaries (which failed, now fixed, in case of bootstrapping tcc with tcc
on OpenBSD) even if -strip-binaries was not set.
The culprit is this code:
ifeq ($(CONFIG_strip),no)
CFLAGS += -g
LDFLAGS += -g
else
CONFIG_strip = yes
ifndef CONFIG_OSX
LDFLAGS += -s
endif
endif
As CONFIG_strip is not set (!= no) it is forced to yes.
Either you pass -strip-binaries option or you install using "make
install-strip" target. The "make install" should only install what has been
compiled so far.
I fixed this by adding "CONFIG_strip=no" to
install: ; @$(MAKE) --no-print-directory install$(CFG) CONFIG_strip=no
Hope it's the right way to fix it, please find another solution if you like.
Christian
_______________________________________________
Tinycc-devel mailing list
[email protected]
https://lists.nongnu.org/mailman/listinfo/tinycc-devel