As it turns out, it's a bug in the igmp snooping code in the kernel that's
the problem with multicast traffic not being forwarded.

This seems to affect recent versions. To check if it's turned on, run
cat /sys/devices/virtual/net/<bridgename>/bridge/multicast_snooping

If it's 1, it's highly this is the culprit causing the non-propagation of
the multicast traffic. The solution is to turn it off by setting it 0.

echo 0 > /sys/devices/virtual/net/<bridge name>/bridge/multicast_snooping



On Sat, May 14, 2016 at 2:54 PM, Liang Guo <[email protected]> wrote:

> > tap0      Link encap:Ethernet  HWaddr ae:a2:e1:cd:aa:68
> >           inet6 addr: fe80::aca2:e1ff:fecd:aa68/64 Scope:Link
> >           UP BROADCAST RUNNING PROMISC MULTICAST  MTU:1500  Metric:1
> >           RX packets:0 errors:0 dropped:0 overruns:0 frame:0
> >           TX packets:2336 errors:0 dropped:0 overruns:0 carrier:0
> >           collisions:0 txqueuelen:500
> >           RX bytes:0 (0.0 B)  TX bytes:1015186 (991.3 KiB)
> >
> > bridge name    bridge id        STP enabled    interfaces
> > br0        8000.7a22d71b042e    no        eth0
> >                                                                tap0
> >
>
> tap0 RX packets is 0, can you double check your tinc config is correct?
>
> You'd better remove tap0 from br0, configure sufficient ip address on
> tap0, then check the connection with other tinc nodes.
>
> --
> Liang Guo
> http://guoliang.me/
> _______________________________________________
> tinc mailing list
> [email protected]
> https://www.tinc-vpn.org/cgi-bin/mailman/listinfo/tinc
>
_______________________________________________
tinc mailing list
[email protected]
https://www.tinc-vpn.org/cgi-bin/mailman/listinfo/tinc

Reply via email to