Finally resolved the problem, I'm actually impressed with the throughput over the tinc VPN!
I encountered & resolved two problems during this installation. First, the config files need to go in different places, depending on whether you run tinc as a service or in the foreground from a Command Prompt running as Administrator (C:\Program Files\tinc\...) or if you are running tinc in the foreground from a Command Prompt running as a normal user, even if the user has administrative privileges (C:\User\AppData\Local\Virtual Store\Program Files\tinc\...). It does not seem to matter to tinc which environment it runs under - you just have to make sure that the VPN & Host files are in the right place for the environment you choose. Second, even after tinc was properly configured, the Norton Internet Security 2010 (NIS 2010) Firewall prevented proper communication in both directions over the VPN. We resolved this problem by establishing 'Full Trust' in the NIS 2010 Network Security Map, both over the Office LAN (for when both nodes are connected to the Office LAN) and also over the VPN (for when both nodes are connected to different LANs). *** NOTE: This did not start working until we brought down the VPN at each end and started it up again at both ends. There were several misleading clues that I came across during the debugging process - one suggested that the 'Stealth Blocked Packets' feature needed to be turned off, which turned out to have no effect; the other was a suggestion from Norton Tech Support (before I was escalated to the software engineering group) to set up a top-priority rule to allow all traffic in both directions between two nodes on a local subnet (There would be up to 2 subnets: The VPN, and the LAN when the remote node attached to the office LAN.) Thanks to Peter & Guus for their help along the way. My next challenge is to set tinc up on my Windows 7 notebook. Kind regards to all, Alan _______________________________________________ tinc mailing list [email protected] http://www.tinc-vpn.org/cgi-bin/mailman/listinfo/tinc
