Hi Albi Thank you for replying, and so quickly. I'm afraid that I still don't fully understand but then I am not really a network guy.
With the host file where my subnet = 10.0.0.3/32 is this a way or writing a single IP with a subnet mask (i.e. 10.0.0.3 and 255.255.255.255) or is this actually specifying an IP range i.e. 10.0.0.3 to 10.0.0.32? If it is the latter, do I need /32 (or /anything) if I only need a single IP address? Also, as this is getting in to the realms of networking that I am not familiar with, would you be able to confirm that the way I have it set up: PC1: host file Subnet = 10.0.0.3/32, interface IP = 10.0.0.3, interface mask = 255.0.0.0 PC2: host file Subnet = 10.0.0.4/32, interface IP = 10.0.0.4, interface mask = 255.0.0.0 is correct and secure? Thanks again Albi, I appreciate your help. Regards Craig. On 11 May 2010 08:44, Albi Rebmann <[email protected]> wrote: > > Although it is working, have I got something wrong? Should the Subnet in > > the local host file not exactly match the subnet in the local TAP > > interface? > > Thank you in advance for any help on this. > > The mask of the interface is the ip range you can use in your tinc vpn > netzwork (cloud). All these ips go to your vpn. > The ip (ranges) in your host file tell the vpn, that this ip(s) is(are) > available at this computer (vpn endpoint). > This way, tinc knows on which endpoint which ip is available. > And you need no extra routing table changes. > > > ALBI... > > > > _______________________________________________ > tinc mailing list > [email protected] > http://www.tinc-vpn.org/cgi-bin/mailman/listinfo/tinc > -- Regards Craig ----------------------------------------------------------- These aren't the droids you're looking for.
_______________________________________________ tinc mailing list [email protected] http://www.tinc-vpn.org/cgi-bin/mailman/listinfo/tinc
